TOGGLE MENU

Beamline Critical Devices

E:HV860

Control Device : E:BNECRD

Areas Protected : MI-12 A, MI-12 B, MI-13

Test Procedure

Note: HV860 shares the same control cabinet with I:Lam10. Both devices will need to be tested.


For E:HV860:
1. Call up digital status for E:BNECRD.

2. Turn on E:HV860 via a parameter page.

3. Verify the digital status for E:HV860 indicates the power supply is ready and on.

4. Issue an off command from the digital status page to the critical device controller.

5. Verify the digital status for E:HV860 indicates the power supply is off.

6. Document the results in the MCR Logbook.

For I:Lam10:
1. Call up the Safety System Status Page for the Main Injector Coasting Beam.

2. Turn on I:Lam10 via a parameter page.

3. Verify the two digital status bits on the Main Injector Coasting Beam Page indicates I:Lam10 power supply is on.

4. Turn off I:Lam10 via a parameter page.

5. Verify the two digital status bits on the Main Injector Coasting Beam Page indicates I:Lam10 power supply is off.

6. Document the results in the MCR Logbook.